Walk-behind floor scrubber -www.xtremepolishingsystems.com
do not use the machine transversally, always manoeuvre with care and do not reverse. When
transporting the machine on steeper ramps or slopes, take the utmost care to avoid tipping up
and/or uncontrolled acceleration. Move the machine on ramps and/or steps only with the
brush head and squeegee raised.
Never park the machine on a slope.
The machine must never be left unattended with the motor or engine on. Before leaving it, turn the
motor or engine off, make sure it cannot move accidentally.
Always pay attention to other people, children in particular, present in the place where you are
working.
Never use he machine to transport people or things or to tow things. Do not tow the machine.
Never rest objects of any weight on the machine for any reason.
Never obstruct ventilation and heat dispersion slits.
Never remove, modify or circumvent safety devices.
Numerous unpleasant experiences have shown that a wide range of personal objects may
cause serious accidents. Before beginning work, remove jewellery, watches, ties, etc.
The operator must always use personal protection devices - protective apron or overalls, non-slip
waterproof shoes, rubber gloves, protective goggles and ear protectors and mask to protect the
respiratory tract.
Keep the hands away from moving parts.
Never use detergents other than those specified. Follow the instructions on the relative safety
sheet. Detergents should be kept out of reach of children. In the event of contact with the eyes,
wash immediately with abundant water. If swallowed, consult a doctor immediately.
Make sure the power sockets used for the models with cable or battery charger are connected
to a suitable earth system and protected by differential thermal solenoid switches.
Make sure the electrical characteristics of the machine (voltage, frequency, absorbed power)
given on the rating plate are the same as those of the mains electricity supply. The machine
with cable has a three-wire cable and a three pin earthed plug for use in an appropriate earthed
socket. The earth wire is yellow and green. Never connect this wire to anything other than the
earth contact of the socket.
It is indispensable to respect the battery manufacturer's instructions and current legislation. The
batteries should always be kept clean and dry to avoid surface leakage current. Protect the
batteries from impurities such as metal dust.
Never rest tools on the batteries as this could cause short circuit and explosion.
When using battery acid, always follow the relative safety instructions scrupulously.
When using cable models, take care not to crush or pull the power supply cable. Check this
cable periodically for damage. If damaged, the machine must not be used.
In the presence of particularly strong magnetic fields, assess the possible effect on the control
electronics.
