Walk-behind floor scrubber -www.xtremepolishingsystems.com
5.
HANDLING AND INSTALLATION
5.1.
Lifting and transporting the packaged machine
During all lifting operations, make sure the packaged machine is firmly anchored to avoid it
tipping up or being accidentally dropped.Always load/unload lorries in adequately lit areas.
The machine, packaged on a wooden pallet by the Manufacturer, must be loaded using suitable
equipment onto the transporting vehicle. At destination, it must be unloaded using similar means.
A fork lift truck must always be used to lift the packaged body of the machine. Handle with care to
avoid knocking or overturning the machine.
5.2. Checks on delivery
When the carrier delivers the machine, make sure the packaging and machine are both whole and
undamaged. If the machine is damaged, make sure the carrier is aware of the damage and before
accepting the goods, reserve the right (in writing) to request compensation for the damage.
5.3. Unpacking
When unpacking the machine, the operator must be provided with the necessary personal
protection devices (gloves, goggles, etc) to limit the risk of accident.
Unpack the machine as follows:
•
cut and remove the plastic straps using scissors or nippers;
•
remove the cardboard;
•
remove the bag which contains warranty card, parts list in the battery tank
•
using a sloping ramp, push the machine backwards off the pallet;
•
unpack the brushes and squeegee (ref pic 8 and 9)
:
pic
(
8
)
pic
(
9
)
•
clean the outside of the machine in respect of safety regulations;
•
after unpacking the machine, install the batteries (battery models)
IMPORTANT
IMPORTANT