Genie Presto Pro Manual
5
Servicing the machine
Preventive maintenance is the responsibility of the operator. It includes:
Checking oil level
Checking and cleaning air and dust filters.
Keeping machine clean and lubricated
Reporting any damaged or worn parts.
See Maintenance section for servicing intervals and instructions.
Servicing or adjusting the propane fuel system should only be done by a trained service technician.
Never attempt to adjust the fuel system of a propane engine! If equipped with an emission
monitoring or controlling system never attempt to disconnect it or circumvent it!
Additional Safety Concerns and Precautions
Operator must have completed training before using machine.*
Sweep floor and check for items protruding out of the floor surface before starting.
Never tilt the machine back while it is running.
Exercise extreme caution when installing or changing abrasive media. The machine is very heavy!
Check for loose bolts and nuts daily
Clean carburetor air filters after four hours running and clean or replace daily before operation.
Clean entire machine after each use including under the gear drive assembly.
Because of the length of time these machines may operate continuously it is very important to be
assured of proper ventilation.
Do not stand on the machine.
Check for wear on drive plates and flex hubs dail
y. Replace if damaged.
Never attempt to bypass or disconnect the kill switch or any future safety devices.
* To arrange for operation and safety training contact STONEKOR by phone at 770.773.3875, email
UH
customerservice@stonekor.com or mail request to P.O. Box 443, Adairsville, GA 30103
Summary of Contents for Genie Presto Pro
Page 16: ......
