8
ATTENTION:
It is possible to damage the engine by allowing it to idle for long periods of time
by affecting proper lubrication.
WARNING!
Exhaust emissions contain harmful toxic gasses; the worst being carbon monoxide.
Always make certain that adequate ventilation is available. Do not operate the machine in confined
areas for prolonged times.
3. It has been the accepted practice to start buffing from the right side of the aisles.
Stopping the Machine
. Put machine in idle mode.
. Close the service valve on the fuel cylinder while the engine is running. This serves to “purge” the
fuel system of all flammable gas.
. Tilt the machine back on its rear caster and allow the engine to run until it stops.
. Turn the key switch to OFF if equipped.
Emergency Stopping
In case of emergency, the machine can be brought to an instant stop by the following methods:
Release “KILL SWITCH”.
Storing the Machine
. Remove the fuel cylinder and store in properly propane storage cage outside (see Propane Fuel
Cylinders).
. After the engine has cooled completely, clean machine thoroughly.
. Perform all daily maintenance requirements.
4. Store machine in a cool, dry, secure area where it will not be damaged by other traffic.
5. Tilt the machine back on the rear caster with the pad off the floor.
Transporting the Machine
•
When transporting the machine from one job to another, secure the machine with the fuel cylinder
installed and the service valve OFF!
•
Allow the engine to cool down before loading it.
Summary of Contents for Genie Presto Pro
Page 16: ......
