Xtreme Power Conversion Corporation
P90g User’s Manual
Page 8
Uninterruptible Power Supply
Diagnostic Tests
When the UPS is started, a diagnostic test is automatically executed, checking the electronics and batteries, report
-
ing any problems on the LCD display.
System Configuration
The UPS device and the internal batteries make up the system. Depending on the site and load require
-
ments of the installation, certain additional options are available for the solution.
Planning a UPS system, the following should be taken into consideration:
• The total demand of the protected system shall dictate the output power rating (VA). Allow a margin for
future expansion or calculation inaccuracies from measured power requirements.
• Backup time required will indicate the battery size needed. If the load is less than the UPS nominal power
rating, then actual backup time is longer.
• The following options are available:
o Connectivity Options – Web/SNMP Card, Relay Card, Modbus Card
o Battery packs, rail kits, bypass switches
o Output Cords
»
IEC C20 to L6-30R
»
IEC C20 to L6-20R
»
IEC C20 to 6-20R
»
IEC C14 to L6-15R
See the Specification section of this manual for additional model information.
P90g front view
P90g-1500 rear view
P90g-3000 rear view