Xtreme Power Conversion Corporation
SPD User’s Manual
Page 20
Power Distribution Unit
Telnet Access:
Enable or disable Telnet access to the system. Default to enable. Only one active Telnet session is permissible.
Enable Telnet Anonymous User:
Enable or disable an anonymous user’s access to Telnet port.
Control command via Emails:
Enable or disable this access method. When it is enabled, you need to make sure you also have completed POP/
SMTP server and email receiving and sending addresses. See “TCP/IP Network Configuration” setup menu for de
-
tailed information how to setup email accounts. Default to disable.
SNMP Agent Enabling:
Enable or disable SNMP agent on the system. If the system SNMP Agent is enabled, it collects and stores man
-
agement information and makes this information available to NMS (Network Management System) using SNMP.
Please see Section 2.5 for a available MIB objects that the system supports. Default to disable.
SNMP Trap Enabling:
Enable or disable Trap sending. If this option is enabled, Traps are sent if there is a power reboot command execu
-
tion on the system. Default to disable.
Note: you must enable the above SNMP Agent setting. Otherwise, enabling Trap setting will not take effect.
SNMP Trap Receiver IP Address:
Enter Trap Monitoring receiver IP address.
SNMP Community String:
To specify SNMP MIB/Trap community string. The default string is “public”. This string is used for public, private
and Trap.
Current A and B Alarm Threshold:
To defined AC current draw alarm threshold. The unit is Amps.
Temperature Alarm Threshold:
To defined temperature draw alarm threshold. The unit is Centigrade.
Serial Port Setup Menu
This section describes serial console port configuration and operating settings. Serial Console Port configuration
starts with the following menu:
Serial Port Setup Menu (Web Page)
