Xtreme Power Conversion Corporation
SPD User’s Manual
Page 6
Power Distribution Unit
1.
Power Outlet status LED: Visual indication of user power outlet On/Off status.
2.
System power On/Off status LED: Indication of system power On/Off status.
3. Ethernet Link status LED: When the LED is illuminated, Ethernet port and a LAN connection are established.
4.
Ethernet speed status LED: Ethernet port have 100M status.
5.
Ethernet Active data status LED: When there is data traffic on the LAN, the LED is illuminated.
6.
Factory Upgrade switch: Allow the user to upgrade the system. The switch is located behind the small front
panel opening.
7. Factory Default Reset switch: Allow a user to reset the system to factory default settings. The switch is located
behind the small front panel opening.
8.
A and B Selection LED: When the LED is illuminated, For Circuits A or B Amps which measurement will appear
on the Digital Displays.
9. Display Selection Amps Indicators: When the LED is illuminated, Amps which measurement will appear
on the Digital Displays.
10.
Display Selection Temperature Indicators: When the LED is illuminated, Temperature which measurement will
appear on the Digital Displays.
11.
Display Selection Button : Each time the Display Selection Button is pressed, the Digital Displays will toggle
Between Amps and Temperature, and the LED indicators will light to show which measurement is currently
selected.
12.
Sensor Port: Temperature only or Temperature and Relative Humidity sensor are measured port.
13. Local Master Port (DCE, 9 pin DB, female, or RJ-45 socket): This is also a service port for the user to configure
and change system operation settings.
14.
USB Port: For software upgrade.
15.
Ethernet Port (RJ45, 10/100 Base-T): 10/100 Based-T Ethernet port for connection to LAN.
18.
Digital Displays: Digital Displays will toggle between Amps and Temperature, and the LED indicators will light
to show which measurement is currently selected.
20.
Power Circuit A - Power Inlet: An NEMA5-15P/IEC320-C14 AC inlet which supplies power (08 Series 1-4 outlets;
16 Series 1-8 outlets).
21.
Power Circuit B - Power Inlet: An NEMA5-15P/IEC320-C14 AC inlet which supplies power (08 Series 5-8 outlets;
16 Series 9-16 outlets).
22.
Power Breaker: System turn power on/off.
23. Power Circuit A - Switched Outlets: AC Outlets that can be switched On, Off or rebooted in response.
24.
Power Circuit B - Switched Outlets: AC Outlets that can be switched On, Off or rebooted in response
Caution:
Sensor interface can be connected only with the sensor provided by the manufacture (Do not connect a
telephone line and so on).
Important Safety Precautions for Hardware Installation
Safety Precautions
It is important that you read this section before attempting any of the hardware installation and maintenance
procedures in this guide.
The following instructions are important for your safety and for the function of the unit. Read the instructions
carefully before the installation
WARNING!
To reduce the risk of fire or electrical shock, never remove the cover of the unit. No user serviceable parts inside.
Repair should be done by authorized service personnel only. The unit should be installed in indoors with ambient
temperature and sufficient airflow.
