TECHNICAL DATA
SPECIFICATION
Charger
100-240V ~ 50/60Hz
Battery
Lithium-ion 2.0 Ah
Charging time
around 1 hour
No-load speed
0-400
I
0-1500 rpm
Torque settings
18 + 1 + 1
Max. torque
25N.M.
Chuck capacity
10mm keyless chuck
Max. drilling capacity for steel
6mm
Max. drilling capacity for wood
16mm
OPERATING INSTRUCTIONS FOR DRILL DRIVER
[I] NOTE:
Before using the tool, read the instruction book
carefully.
INTENDED USE
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger. The Li-ion battery is protected against
deep discharging. When the battery is empty, the machine
is switched off by means of a protective circuit: The
tool holder no longer rotates. In a warm environment or
after heavy use, the battery pack may become too hot
to permit charging. Allow time for the battery to cool
down before recharging. When the battery pack is
charged for the first time and after prolonged storage,
the battery pack will accept a 100% charge after
several charge and discharge cycles.
RECHARGEABLE BATTERY
INSTALLATION/REMOVAL
Hold the handle tightly and push the battery latch (6) to
remove the battery (see Fig.1)
Insert the battery while observing its direction. Do not
apply too much force when installing the rechargeable
battery. Check the correctness of it installation.
8
Summary of Contents for 47519
Page 13: ...12 ...
