4
PRODUCT INFORMATION
INSTALLATION
1.
Assemble the four connection knobs on the upward and downward tube.
2.
Put the drive cable and auger cable into the trigger hole.
3.
Connect the turning alignment pin and spring with the pin fixing seat housing and fix them with the cable
adapter sleeve. Then fix the cable adapter sleeve by bolt.
4.
Put the speed handle into speed spacing frame, then fix the handle on the body of the machine by screw.
STARTING THE ENGINE
1.
Turn the switch to ON.
2.
Open the choke and accelerator and then pull the starter cord to start it.
3.
Plug the power cable into the wall socket.
4.
Don’t push the electric button until you are sure that the power line is properly connected with the power
source.
5.
Get the plug out and close the cover when the engine is started, then close the choke.
STOPPING THE ENGINE
1.
Turn the engine switch to OFF and the engine will turn off.
LEFT/RIGHT HANDLEBAR CLUTCH OPERATION
1. Operation of the clutch on the left handlebar:
The clutch on the left handlebar controls the brush
operation through the clutch on the handlebar.
A.
In the loosing position, the sweeper won’t start sweeping.
B.
Press the clutch downward and the sweeper will start to work.
2. Operation of the clutch on the right handlebar:
The clutch on the right handlebar controls the drive
control. The user will be able to choose the speed gear according to the need and move the equipment
forward at various speeds.
Left Handlebar
Right Handlebar
SELECTION OF SPEED TRANSMISSION
1.
This unit has a 6-gear transmission that can be chosen by adjusting the speed transmission rider.
A: Four Forward B: Two Reverse
OPERATION OF SUPPORT WHEEL
The support wheel helps support the turning of the unit and also for adjusting the height of the brush.
A.
Increase the height of the brush by rotating the rider of the support wheel counter-clockwise.
B.
Decrease the height of the brush by rotating the rider of the support wheel clockwise.
ADJUST THE DIRECTION OF THE BRUSH
Press the direction adjustment rider of the brush and adjust the direction of the brush roller.
A.
Turn the brush to the right by pushing the machine to the right.
B.
Turn the brush to the left by oushing the machine to the left.
