4
NOTE
: This log splitter is assembled at the factory and has been pre-filled with hydraulic oil. Refer to the
diagram below should it become necessary to disassemble the unit for repair or replacement of parts.
NOTE:
This machine is only intended for homeowners and non-commercial users to split firewood as
detailed in the instructions and not for any other purpose.
NOTE:
Ensure the power supply is not conneted while preparing the log splitter for use.
NOTE:
If hydraulic fluid is difficult to obtain, Dextron automatic transmission fluid can be substituted. Use
only clean oil and be sure to prevent dirt from entering the hydraulic reservoir. Do not mix AW32 hydraulic
fluid with Dextron hydraulic flud. Log splitter is shipped with AW32 hydraulic fluid.
IMPORTANT:
Before operating the log splitter, turn the bleed screw two turns to allow air to be released
from the hydraulic system. A flow of air through the bleed screw should be detectable while log splitter is in
use. Close the bleed screw after operation. Make sure the bleed screw is closed before and during transport.
Failure to loosen the bleed screw will cause pressure to build up in the hydraulic tank
and could damage the seals and affect the operation of the log splitter.
ASSEMBLY
Summary of Contents for 65061-XP
Page 8: ...PARTS DIAGRAM 7 ...
Page 9: ...PARTS LIST 8 ...