Xtreme Power 81094, Owner'S Manual And Safety Instructions

4

CARBON MONOXIDE PRECAUTIONS

FIRE AND EXPLOSION PRECAUTIONS

CHEMICAL PRECAUTIONS

1. 

Fill the fuel tank: To obtain the proper 25:1 fuel mix, combine 25 parts 

unleaded gasoline (89+ octane) with 1 part 2-cycle oil in the provide Fuel 

Mix Container (36a). Cover and shake to thoroughly mix before each 

fueling. 

PRE-START INSTRUCTIONS

NOTE: 

Mix only enough fuel for a few days work. The maximum storage 

time of mixed fuel is three months.

2. 

Once the proper fuel mix is obtained, removed the Fuel Cap (93). Fill the Fuel Tank (89) approximately ¾ 

full with the fuel mix. Then replace the Fuel Cap. See Figure B.

WARNING: 

Do not attempt to fill the Fuel Tank (89) when the engine is running or hot to the touch.

IMPORTANT: 

Your warranty is voided if you do not operate the Auger Drill with the proper amount of SAE 

80-90 gear oil in its Gearbox (8a). 

DO NOT

 run the Auger Drill with low or no gear oil. Running the unit in 

this manner can permanently damage the unit. 

FILL THE GEARBOX

1. 

Remove  the  Oil  Fill  Plug  (20a)  and  carefully  fill  (approximately  8-1/2  ounces)  the  Gearbox  (8a)  then 

replace the Oil Fill Plug and tighten securely.  See Figure B. 

NOTE: DO NOT

 use dirty, used or otherwise contaminated Gear Oil. Damage may occur to the internal 

mechanisms of the Gearbox. 

OPERATION