Xtreme Power 90154, Owner'S Manual And Safety Instructions

7

OPERATION

Determining Pool Size (Gallons of Water in Your Pool)

CAUTION

:  To protect the lifetime of CFPT, never use dry acid (sodium bisulfate) to adjust pH in arid geographic 

areas with excessive evaporation and minimal dilution of pool water with fresh water.

LED LIGHT INSTRUCTION

SUPERCL /SALINITY: SHORT PRESS:

 Show the salinity

LONG TIME PRESS: 

Enter into SuperChlor mode, long time press 

again to exit setup. SuperChlor mode will auto-exit after 24 hours.

GENERATE: 

The cell is operational and ready.

COLD WATER: 

It warns water temperature either below 10°C or 

above 50°C--system off.

SALT: GOOD LED ON: 

Good salt. It shows the Ideal Salinity: 2800 

PPM to 4500 PPM

INSPECT SALT RED ON: 

Salt Level below 2300 PPM or above 

6000 PPM

INSPECT  SALT  RED  (flashing): 

Salt Level:2300 PPM to 2800 

PPM/4500 PPM to 6000 PPM

CELL: GOOD LED ON: 

The cell is good and producing chlorine. 

INSPECT CELL RED:

 The cell needs to be 

inspected. The blades may have calcium. The cell is not producing chlorine.

FLOW: GOOD FLOW LED ON: 

Sufficient water flow to produce chlorine.

NO FLOW LED FLASHING: 

There is water flow. Continuous detection of water for one minute

SANITIZE OUTPUT SETTING: 

Press the button MIN and MAX, 10% each setting.