3.
Test the Brake shutdown circuit
: With the vehicle running under the Remote
Starter, press and release the Brake Pedal. The Engine should shut down
immediately. If the Engine continues to run, check the Brake Switch connection.
4.
Door Locks, Auxiliary Outputs and Trunk Testing:
Make sure each of these
options respond to the Transmitter (if they were installed).
5.
Starter Kill option:
Sit inside the vehicle with all the Doors closed. Arm the vehicle
and then try to start the vehicle with the key –it should not start. If the vehicle starts,
rewire the starter kill so it functions properly.
6.
Valet Mode:
Make sure the Module is able to enter and exit Valet Mode properly.
When setting the Module into Valet mode, the Starter Kill function is disabled, when
pressing
LOCK
the Doors will lock but the Starter Kill will not be activated. (Refer to
User Guide for more information on Valet Mode)
7.
Idle Mode:
Make sure the vehicle properly goes into Idle Mode.
Closing Up
Use tie-wraps or screws to properly secure the Module and keep the wiring away from any
moving parts such as the Parking Brakes or Steering Column Shafts. Mount all switches in
good and accessible locations where they do not risk getting kicked or hit accidentally. Any
under hood wiring should be split loomed and tie strapped away from moving parts and heat
sources.
Always make all your connections before plugging in the Module. Keep in mind to plug the
fuses as
the last step before the initial powering of the Module
. Be sure to test all
functions properly before closing up the installation.
Make sure the Warning Label is applied on a visible place under the Hood.
Supplementary Information
The following features can be programmed according to the user’s needs and the requirements
of the installation.
Fifth Relay Output (2nd Ignition or 2nd Accessories or 2nd Crank Output)
The Module comes equipped with a high-
current programmable 5
th
relay which can be
used to power a 2
nd
Ignition, Accessory, or
Crank Wire.
The Unit uses three sets of pins. Each set of
pins has a function. To activate one of the
three possible 2
nd
outputs, place the Jumper
(supplied) on one of the three sets of pins
and connect the green 14 AWG wire either to
the 2
nd
Ignition wire, to the Accessories wire
or to the Crank wire of the vehicle.
Note:
Only one set of pins can be used at a time.
Caution:
The relay output rating on this Unit is 25 A at most. Defective OEM solenoid switches can
sometimes draw up to 50 or 60 A, causing the 30 A fuse to blow. Always check your circuit with a
proper measuring device.
P. 14
Installation
Guide
