Flashing the Hood Pin
What is Flashing the Hood Pin?
It is a procedure that makes the Module go into the Programming Centre. Once the Module
is in the Programming Centre, the Installer has no more than 20 seconds to get into one of
the sub-menus.
Failure to do so will result in the Module exiting the Programming
Centre and the Installer will have to
Flash the Hood Pin
once more.
Remember
:
You can use the Programming Assistance
Button instead of the Hood Pin any time the Hood is up.
The Installer …
The Module …
1-
Press and hold the Hood pin for 4 seconds.
2-
Let go of the Hood Pin.
Parking Lights “ON”
3-
While the Parking Lights are on, press down the Hood
Pin once more.
4-
Release the Hood Pin again --be careful not to over
flash the Hood Pin as this will bring up the Events
Playback and will not bring you the Programming
Centre.
“ON” for 20 seconds
5-
You now have 20 seconds to select one of the sub-
menus.
Once inside the Programming Centre, the Installer has a selection of many different sub-
menus. Once you are in the Programming Centre, you have the option of the following
menus:
a)
Transmitter Programming …………………..
p.10
b)
Options Programming …………………..…
p.11
c)
Honk Horn Timing* (*if available) ………..…
p.12
d)
Tach Programming …………………..………
p.13
Remember:
You have up to 20 seconds, once the Parking Lights are on Solid, to select a sub-
menu, Failure to do so will result in the Module exiting the Programming Centre and the Installer
will have to Flash the Hood Pin once more.
The Programming
Assistance Button
(A.k.a. PAB.)
The PAB is located on the
side of the Module. This
push button mimics the
Hood-Pin switch in order to
avoid having to get out of
the vehicle and pressing the
Hood-Pin switch.
The PAB
will work only when the
Hood is up.
Installation Guide
P. 9
