Xtreme Power Conversion Corporation
G90 User’s Manual
Page 50
Uninterruptible Power Supply
2.
On the bottom of the UPS front cover, remove the EBP cable knockout
3.
Plug the EBP cable(s) into the battery connector(s). A small amount of arcing may occur when connecting
an EBP to the UPS. This is normal and will not harm personnel. Insert the EBP cable into the UPS battery
connector quickly and firmly. Up to four EBPS may be connected to the UPS. Connect red to red, black to
black, and yellow to yellow. Press the two parts tightly together to ensure a proper connection.
To connect a second EBP, unclip the EBP connector on the first EBP and pull gently to extend the wiring to the EBP
connector on the second EBP. Repeat for any additional EBPs.
4. Verify that the EBP connections are tight and that adequate bend radius and strain relief exist for each
cable.