11
LIstenIng to Your DevIce through the
auXILIarY LIne-In jack
Connect a 3.5mm audio cable (available at
1.
www.xtrememac.com
) to the headphone or line out jack of an
audio device and plug the other end of the cable into the Aux
jack on the back of the unit.
Press the
2.
on the top of the unit or the remote to power on
Tango TRX.
Press the source button on the unit until the LED under the Aux
3.
icon is illuminated.
Press play on the device. Use the control knob on the unit to
4.
control the volume.
aDjustIng Bass anD treBLe
While playing audio, press the bass or treble control on the unit
and use the control knob to adjust the setting. The LEDs on the
unit will illuminate from the center to indicate the level of bass
and treble at +/- 4 for each setting. You may also adjust the bass
and treble with the remote.
LeD InDIcators
SOURCE
The LED under the source icon will illuminate when pressing the
source control to indicate the source selected. Once selected the
LED will remain illuminated.
VOLUME
The LEDs will illuminate in sequence when adjusting the volume
to indicate volume level. The LEDs for volume will time out after 2
seconds and only the LED for the source will remain illuminated.
BASS/TREBLE
The LEDs on the unit will illuminate from the center to indicate
the level of bass and treble at +/- 4 for each setting. The LEDs for
volume will time out after 2 seconds and only the LED for the
source will remain illuminated.
trouBLeshootIng tIPs
no Power
Check AC adapter connection on unit
Connect the AC adapter into the jack in the back of the unit labeled
"18V
2.5A" and then plug the AC adapter into the wall outlet.
Check wall outlet function
Plug another device into the same outlet to confirm the outlet is
working.
IPU-TRX-13_user_guide_23950664E.indd 11
8/15/11 10:11:30 AM
Imation Confidential - Use Only By Permission
Controlled material extracted from Matrix on Nov 29, 2012 10:03:45 AM CST