Tango X2 User’s Guide | 5
Unpacking and Initial Setup
1.
Remove Tango X2 from the box and remove foam and
protective plastic. Keep original packaging for 90 days and
then properly dispose.
2.
Place Tango X2 on a level surface following the precautions
listed in the safety warnings. For best sound, make sure to
leave some room between the back of the unit and a back
wall so that air can pass through the bass port.
3.
Remove AC adapter, remote and AM/FM antennas from the
packaging.
4.
Read and review manual and safety warnings
5.
Connect the AC adapter into the jack on the back of Tango
X2 labeled “18V DC ”, then plug the AC adapter into the
wall outlet.
6.
Connect the FM antenna into the “FM” jack on the back of the
unit. Untie and extend the antenna.
7.
Connect the AM antenna into the “AM” jack on the back of the
unit.
Listening to your iPod
1.
Remove the plastic cover protecting the dock connector and
dispose of properly.
2.
Use the insert that came with your iPod and gently press it
into the universal dock well.
3.
Carefully place your iPod into the dock well
4.
Press the control wheel on the front of the unit or press
power on the included remote to turn on the power. The
display will light “iPod” to indicate the unit is powered up
and an iPod is properly docked. The display will turn off after
10 seconds.
5.
Press play on the top of the unit, on the iPod or on the
remote.
6.
Turn the control wheel on the front of the unit or use the
volume controls on the remote to adjust the volume to the
desired level.
7.
Use the controls on the top of the unit or the remote to
play/pause and for next/previous track. For more advanced
functions, use the iPod controls.
8.
Press and hold the control wheel on the front of the unit for 2
seconds to turn of the power. To conserve energy, the unit
will automatically power off if no audio is detected after 7
minutes.
Note: If you dock a playing iPod, the unit will automatically
switch to iPod mode and start playing. If you dock an iPod that is
not playing, it will automatically switch to iPod mode, but you
will have to press play on the unit, the remote or the iPod itself.
tango_x2_manual_eu_new.qxd 1/25/08 3:51 PM Page 7
