40
Figure 4-18
4.5
Detect
4.5.1
Go to Detect Menu
In the main menu, from Setting to Detect, you can see motion detect interface. See
X302H302H302H
Figure 4-
19.There is three detection types: motion detection, video loss, camera masking.
4.5.2
Motion Detect
Detection menu is shown as below. See Figure 4-19.
z
Event type: from the dropdown list you can select motion detection type.
z
Channel: select the channel to activate recording function once alarm occurred. Please make
sure you have set MD record in encode interface(Main Menu->Setting->Schedule) and schedule
record in manual record interface(Main Menu->Advanced->Manual Record)
z
Latch: when motion detection complete, system auto delays detecting for a specified time. The
value ranges from 10-300(Unit: second)
z
Region: Click select button, the interface is shown as in
X304H304H304H
Figure 4-20.
Here you can set motion
detection zone. There are 396(PAL)/330(NTSC) small zones. The green zone is current cursor
position. Grey zone is the motion detection zone. Black zone is the disarmed zone. You can click
Fn button to switch between the arm mode and disarm mode. In arm mode, you can click the
direction buttons to move the green rectangle to set the motion detection zone. After you
completed the setup, please click ENTER button to exit current setup. Do remember click save
button to save current setup. If you click ESC button to exit the region setup interface system will
not save your zone setup.
z
Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity.
Select search
engine here
You can see result here. Double click
file name, you can view the image
content.
There are max 100 files in one
page. Click here to view more.
Select a file and then
click here to view
image content.
