28
detection area. Click
icon to clear the set detection area. Click
icon to test the
sensitivity as per the local conditions. Once motion is sensed, it displays a figure icon.
Click
icon, to save the setting. Click
icon to exit the current interface.
Note:
Prior to setting motion detection field it is recommended that you click
icon to clear the existing field and set afresh.
⑥
Select “All” to set the same settings for all channels.
⑦
Click “Apply” button to save the setting.
⑧
Go to Schedule tab. The setting steps for schedule for motion based alarm are similar to
normal schedule setup (see Chapter 5.4.1 for more details).
5.5.3 Other Alarm
This tab gives a choice to configure alarm for Disk Full, IP Conflict, the Disconnect event, etc.
①
Go to Main Menu
Setup
Alarm
Other Alarm. Refer to Fig 5-21.
Fig 5-21 Other Alarm
②
Use the dropdown menu and select the event or the alarm.
③
Check the required trigger options.
If the selected event is “Disk Full”, then use the drop down box for “Disk Shortage Alarm” to
choose a threshold value for remaining HDD space. If the threshold value is reached, the
system will trigger the Disk Full Alarm.
④
Click “Apply” to save the setting.
5.5.4 Alarm Out
Alarm out includes three sub menus: alarm out, schedule and buzzer.
To set up alarm out:
①
Go to Main Menu
Setup
Alarm
Alarm Out
Alarm Out. Refer to Fig 5-22.
