Preparation
10
Please refer to the following code to check the failures:
PAN FAIL
Failure of pan initialization
TILT FAIL
Failure of tilt initialization
CAM FAIL
Failure of block camera initialization
P/T FAIL
Failure of pan and tilt initializations
T/Z FAIL
Failure of tilt and block camera initializations
P/T/Z FAIL
Failure of pan, tilt and block camera initializations
Installation Place
Make sure the installation place has enough space, support strength to install the whole PTZ
camera and its accessories.
[Note]
In case of P/T failure:
If the ambient temperature is below 5
℃
, the heater will be turned on and the PTZ
camera will do the initialization again.
If the ambient temperature is above 5
℃
, please reboot the PTZ camera.
DOME ID
:
001
PROTOCOL
:
PELCO-D/P
BAUD
:
9600
SOFTWARE VER
:
1.4.4
CAM FAIL