Mounting and connecting tips
Mounting alternatives
The wall behind and the wall beside the loudspeaker
have influence on both the bass level and the bass
characteristics, so please be patient and try different
distances to the rear and side walls.
Connecting using the
correct phase
Always connect using the correct phase, from the +-
pole on the amplifier to the +-pole on the
loudspeaker and corresponding for minus (-).
If you by accident connect the other
way, there is no risk of damage.
However, the sound will not be
correct, especially in the
lower frequencies.
Overload
At high load during extensive time periods, there is
always the risk of overloading the driver and
amplifier.
All loudspeakers have a limited
patience for high power, so be
careful not to play extremely loud
and not to increase treble or bass
settings to much.
By increasing the bass or treble from
0 to max you will increase the power
by about 16 times.
The initial playing time
It takes about 50 to 100 hour of initial playing time,
for the driver to sound optimal. During this time,
the speaker may be used normally.
8
