7
Mounting and Connecting tips
Mounting
alternatives
The wall behind and the wall beside the
loudspeaker have influence on both the bass level
and the bass characteristics, so take your time, be
patient and try different distances to the rear and
side walls.
Connect using the
correct phase
Be aware of the correct phase, from the + pole on
the amplifier to the + pole on the loudspeaker and
corresponding for minus (-).
If you accidently connect the other way,
there is no risk of damage. However, the
sound will not be correct, especially in the
lower frequencies.
Overload
At high load during extensive period of time, there
is always a risk of overloading the driver as well as
the amplifier.
All loudspeakers have limited high power
patience, so be careful not to play
extremely loud.
By increasing the bass or treble from
average level to maximum it will increase
the power by about 16 times.
The initial playing
time
It takes about 100 hour of initial playing time, for
making the driver to sound optimal. During this
time, the speaker may be used normally.
