Xvent s.r.o.
Poděbradská 289
53009 Pardubice-Trnová
Verze 001-GBR (25.8.2022)
Page
2
z
6
D-502-0283
- How to install Xflat unit
a)
Remove the unit from its
b)
Choose the installation position taking into account the location of the
condensate outlet. Align the anchor holes according to the dimensions on the
unit, drill and mount the unit leveled using suitable screws. Do not tilt the
unit.
- Before starting the unit for the first time or after a longer standstill, check the water trap. If you make a bend on the hose, pay
attention to the correct bend radius to avoid "breaking the hose". To extend the siphon hose, always choose a hose - pipe of the same
or larger diameter. Always choose the hose-pipe coupling with the smallest reduction of the inner diameter.
- All pipe connections that are connected to the unit must be sufficiently sealed so that there were no unwanted leaks and subsequent
problems, e.g.: condensation. the connected piping must be of the same diameter as the unit's connection sockets. If a pipe with a
smaller diameter is used, it may affect the air performance of the unit and thus reduce the lifespan of the fans.
f)
Fill the siphon by water,
connect the hose to the outlet of
the unit and secure with a strap
h)
connect the air ducts to
the Ø100mm nozzles
according to the purpose
c)
cut off the edge of the condensation outlet and remove
any burrs
e)
choose the correct siphon position
for connection to the sewer
m
in
1
50
m
m
min 150mm
g)
connect the siphon
to the sewage system
i)
seal and insulate the joint - use the
thermal insulation of the throats
m
in
1
50
m
m
INSULATION NECESSARY
d)
create a siphon by attaching
the hose and tie straps
Horizontal on the wall
Vertical on the wall
Under the ceiling
