16
Version 1 – GBR (25/10/2022)
D-502-0287
Please, return all the not needed packaging to the appropriate recycling points where
they will be disposed of professionally. Only packaging recycled in this way can be
reused properly and returned to utility.
Fig. 8
3.
Unit Installation
3.1.
General information, recommendations, and safety when installing the Xhouse unit
3.1.1.
Electrical safety before installation of the unit
-
Before starting any installation work, make sure that the wiring box or mains socket that you want to
use to connect the unit is equipped with a protective (green-yellow) wire or contact (pin).
-
If you use a wiring box to electrically connect the unit, you must turn off the power and secure the power
supply against accidental turn on.
-
Check that the electrical connection point (wiring box, outlet) meets the unit's power supply requirements
(voltage, current, etc.) specified on the unit's serial plate. The electrical quantities necessary for the unit's
operation can be found in Section 3.3.3. “Display of electrical parameters”
3.1.2.
Unpacking the Xhouse unit
-
Always unpack the unit in a sufficiently large area to allow for removing the unit from the packaging.
-
Never unpack the entire unit from the packaging, the unpacking of the unit must be gradual, as specified
in this manual according to the installation work in progress (protection of the unit from damage and dust
generated during installation)
-
Follow these steps:
1
2
3
Fig. 7
