XC Camera Setup and OSD Guide
Gamma: CURVE_1_6
，
CURVE_1_8,CURVE_2_0,CURVE_2_2 totally four modes,
default is CURVE_2_0
Anti-Flicker: Auto, 50hz, 60hz, the default is Auto
After all parameter settings are completed, click “Save” these settings will take
immediate effect.
Motion Detection
Enable: Select to enable the motion detection function.
Alarm Schedule: Set the alarm schedule from Monday to Sunday.
Drawing: Click Drawing, then set the motion area.
Clear: Click Clear to clear the current motion areas.
Sensitivity: The higher of the sensitivity, the motion will be detected.
Email: Send Email to appointed mailbox when alarm triggered.
Snap: Snapshot and install the picture in the HDD when alarm triggered.
Record: Record in the HDD when alarm triggered.
Alarm Output: Connect the alarm output port, alarm triggered the embedded relay
switch to call alarm output.
Enable PTZ: Alarm input to link the PTZ motion.
