6
Dome Camera Control
Dome Camera Connection & Settings:
•
See section
Pin Definition of Alarm I/O & RS-485 for RS-485 port pin definition.
•
Refer to the following figure. Connect the R+, R− terminals on the dome camera to the D+, D−
terminals on the RS-485 port by RS-485 cable respectively.
•
To set up dome camera’s protocol and ID, press
MENU
to access the OSD main menu, and
select <
Camera Setup
>. The available protocols include <
DSCP
>, <
Pelco D
>, <
Pelco P
>,
<
AD422
>, <
Fastrax 2
>, <
JVC
>, <
Panasonic_C
>, and <
Panasonic_N
>. The default is
<
None
>. Note that ID number must match the ID address defined by the dome camera.
•
To configure the RS-485 parameters, select <
System Setup
> from OSD main menu, and then
select <
RS485 Setup
>. The default
RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and
No Parity.
Control Buttons in Dome Camera Control Mode:
1
Set / Go Preset
5
Pan / Tilt
9
Iris Close
13
Zoom In
2
Toggle Hint Screen
6
Enter Dome Camera
Control Mode
10
Focus Far
3
Go Presets 1~6
7
ESC
11
Focus Near
4
Enter / Auto
8
Iris Open
12
Zoom Out
