Ice Cube Maker
EN
17
• Thoroughly wipe down the device
(inside and outside) and the ice cube
container and the ice cube scoop with
a dry cloth.
• Store the device in a dry, clean, frost-
free place that is protected from di-
rect sunlight and cannot be accessed
by children or animals.
Cleaning Programme
The device has a cleaning programme
which should be used at least once or
twice a month, and more frequently if the
device is used regularly.
1. Drain any remaining water (see previ-
ous section).
2. Soak a cloth in a water/vinegar solu-
tion and use it to wipe the inside of
the device.
3. Fill the water tank (
6
) with fresh water
(see the “Preparation” chapter).
4. Plug the connecting cable into a plug
socket that is easily accessible. The
symbol for the set ice cube size (
10
or
11
) lights up and the
symbol (
9
)
flashes.
5. Press the
SELECT
button (
15
) to select
the cleaning programme
(
14
).
6. Start the cleaning programme by
pressing the
ON / OFF
button (
16
).
The
symbol is lit constantly. The
device pumps the water through the
device for approx. 6 minutes and then
switches to stand-by mode.
7. Use the device in the usual way or
prepare it for storage (see previous
section).
TROUBLESHOOTING
If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps that are listed,
contact the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device does not work.
The mains plug is not inserted in the plug
socket correctly.
►
Correct the fit of the mains plug.
The plug socket is defective.
►
Try another plug socket.
There is no mains voltage.
►
Check the fuse of the mains connec-
tion.
The device was not started.
►
Press the
ON / OFF
button (
16
) to
start the production of the ice cubes
or the cleaning programme.
The ice cube container (
7
) is full. /
The
symbol (
12
) lights up.
►
Empty the ice cube container. The
device carries on working automati-
cally.
The water tank (
6
) is empty. / The
symbol (
13
) lights up.
►
Fill the water tank and restart the
device by pressing the
ON / OFF
button (
16
).
The fuse in the fuse box is triggered.
Too many devices are connected to the
same circuit.
►
Reduce the number of devices in the
circuit.
