![background image](http://html1.mh-extra.com/html/xy-powersports/xy500utv/xy500utv_service-manual_3829184070.webp)
4. COOLING AND LUBRICATIING SYSTEM
4-6
I
nspection of Water Temperature Sensor
●
Place a rag under water temperature sensor
①
and
remove it from cylinder head.
●
Check the resistance of water temperature sensor
as illustrated on the right. Connect the temperature
sensor
②
to the circuit tester, place it in a vessel
with engine oil. Place the vessel above a stove.
●
Heat the oil to raise the temperature slowly and take
the reading from thermometer
③
and ohmmeter
④
.
Water Temperature and Resistance
Temperature(
℃
)
50 80
100
120
Resistance(
Ω
)
154±16
52±4
27±3
16±2
Installation:
Apply a little thread locker and install it to
the cylinder head by tightening to the specified torque.
Water Temperature Sensor
Tightening Torque: 10N.m
●
After installation, check the coolant level. Fill
coolant if necessary.
Inspection of Thermostat
●
Remove thermostat case
●
Remove thermostat
Note:
●
Avoid sharp impact on temperature sensor
●
Avoid contact of temperature sensor with
thermometer or vessel
4
Summary of Contents for XY500UTV
