Xybix Systems, Inc. • 8207 SouthPark Circle • Littleton, CO 80120 • 800.788.2810 • www.xybix.com
28
Copyright © Xybix Systems, Inc.
March 2019
WELCOME TO YOUR XYBIX FURNITURE
Operations Trouble Shooting Guide
Trouble shooting your console
Hand Control (T2 and T3 Tables)
(If your table has two or three legs, this should be your hand control)
Located on top of the work surface Xybix hand controls offer an easy way to operate a dual surface or
single surface console.
Hand Controls are used to adjust console height and with a push of a button, can be used in for the
seated or standing position.
Procedure for Reset and Initializing:
1. Once you have fully assembled your desk. It needs to be initialized at the lowest position.
2. Ensure there are no obstructions which would prevent the desk from moving vertically.
3. Hover your fingers over the “UP and DOWN” arrow buttons at the same time.
4. Continue to hover over the “UP and DOWN” arrow buttons, the desk will lower until it reaches the
bottom.
5. Once the system beeps, release the “UP and DOWN” buttons.
a. If it does not beep, continue to hover over the buttons for 3 seconds after the desk reaches
the lowest point.
6. The system has now been synchronized and the table is now ready for use.
Memory Set Positions:
1. To be performed after “Reset and Initializing”.
2. Move the desk to the desired memory position.
3. Press and hold the M button until the display flashes.
4. Repeat for programming positions 2 and 3.
Moving to a memory preset position:
1. Ensure there are no obstructions which would prevent the desk from moving vertically.
2. Press and hold the memory button #
3. The desk will move to the preset position.
