1341Embedded Node PC
Chapter 3 – Award BIOS Setup
10
144810(C)
Jumper Settings
The CPU board has a number of jumpers that allow you to configure your system to suit your
application. The table below shows the function of each of the board’s jumpers:
Jumper
Function
JP1
ATX Power to AT Function
JP2
Audio Out Selection
JP3
LCD Voltage Selection
JP4
COM4 Ring/+5V/+12V Selection
JP5
COM3 Ring/+5V/+12V Selection
JP6
Clear CMOS
JP6: Clear CMOS Setup
If the CPU board fails to boot due to improper BIOS settings, use this jumper to clear the CMOS
data and reset the system BIOS information. To do this, use the jumper cap to close pins 2 and 3
for a few seconds then reinstall the jumper clip back to pins 1 and 2.
If the “CMOS Settings Wrong” message display during the boot up process, you may then try to
correct the fault by pressing the F1 to enter the CMOS Setup menu. You may then do one of the
following:
•
Enter the correct CMOS setting
•
Load Optimal Defaults
•
Load Failsafe Defaults
After you have done one of the above options, save your changes and exit the CMOS Setup
menu.
JP6
Description
1-2
Normal
2-3
Clear CMOS
