ISA/PCI EXPANSION
The 1614 comes with a choice of backplanes: eight ISA and four PCI or five ISA and
seven PCI available expansion slots.
To Add ISA/PCI Cards
1.
Check that the memory, I/O configuration, and processor requirements for the
board you want to install do not conflict with the CPU and memory maps of
boards already installed in your system. Refer to pages 44-48 for information about
the SBC-370 and SBC-SLOT1 boards.
Warning:
To prevent any component damage or injury, please make sure your 1614
unit is completely powered down before performing any installation or maintenance
and wear a ground wrist strap or other static-dissipating device.
2.
Open the unit as described on page 12.
3.
Remove the hold-down bar by removing the seven screws securing it (two connect-
ing the hold-down bar to the 5.25" drive bay, two on the left side when facing the
front panel, and three on the right side when facing the front panel). Lift the bar
out of the unit.
4.
Remove the ORB cover for the slot that the card will occupy. Save the screw.
Note:
When installing cards into a system equipped with the combination ISA/PCI
backplane, you may install an ISA card in the shared ISA/PCI slot or a PCI card in the PCI
slot immediately adjacent to it. Due to physical clearance limitations, you may NOT in-
stall an ISA card in the shared ISA/PCI slot and a PCI card in the adjacent PCI slot.
Hardware Options
20
Figure 10. Card assembly.
