PS/2 keyboard connector:
A keyboard can interface with the system through this six-pin
PS/2-compatible connector.
•
Refer to page 42 for pin assignments for the keyboard connector.
Note:
Do not connect a keyboard to this front connector if a keyboard is plugged into the key-
board connector on the rear panel. Doing so may cause the keyboards to operate improperly.
3.5" drive bays:
These front accessible bays can hold up to two 3.5" storage devices, in-
cluding 1.44 MB floppy, LS-120, and internal hard drives.
5.25" drive bays:
These bays hold up to three 5.25" mass storage devices, including
CD-ROM, CD-Writable, Zip, 5 GB tape, removable 6.4 GB hard, or removable 12 GB
hard drives.
Note:
The 1614 holds a maximum of four IDE devices. Therefore, only two 5.25" mass
storage devices can be accommodated when both the LS-120 and internal hard drives are
installed in the 3.5" drive bays.
Removable drive lock:
If a removable drive is installed in the system, it must be locked in
order to operate. The display above the lock displays an
O
when locked and a
U
when
unlocked. The display also flashes when the removable hard drive is active.
Product Overview
10
