Page | 14
Figure 4 - Terminal Plate Schematic
2.4
USB Port
It is possible to power the Ai1 using the USB port to allow easy configuration, program
and firmware uploads and basic operation. While powered from the USB port alone,
functionality is limited. USB power does not power the internal modem, the SW12V port,
and voltage from Vx1 and Vx2 are limited to 2.5V. The USB port does not charge the
internal batteries (use the charger port instead). A waterproof vent provides
secure access to the USB port, power switch and fuse without needing to remove
the clear plate. Use finger strength only to tighten and remove.
Use finger strength only to open or close the port vent
Push the USB cable into the port through the entry
CUSTOM
CUSTOM port used for expansion options such as
EXO Signal Output Adapter
Figure 5
–
A USB Micro-B cable is
supplied for USB port access. Make sure
a
data
cable is used, not a charge-only
cable the connection will fail.
