6 Operation
6.1 Configure and install the optimyze sensors
Follow the optimyze Quick Start Guide to configure optimyze sensors before setting up
Gateway.
6.2 Set up optimyze Gateway
1. Connect the antennas present in the packaging while paying attention to the insert on the
Gateway (each antenna corresponds to a specific insert on the Gateway).
2. Connect Gateway to power supply.
3. Turn on Gateway with the
Power switch.
4. The Gateway will connect to the cellular network and xylem cloud. Note that this could
take a few minutes. Once it successfully connects, the red LED goes from blinking to a
solid red state and green LED will also turn on. Blue LED starts blinking with 5 second
interval.
5. To pair with optimyze sensors:
a) Put the first optimyze sensor in configuration mode by positioning the magnet
supplied with the sensor over the Bluetooth symbol until the LED blinks pink.
b) Once the sensor is in configuration mode, press Bluetooth button on the optimyze
Gateway. Blue LED starts blinking with a one second interval indicating pairing mode
is active. Pairing mode is active 90 seconds.
c) The Gateway will now attempt to pair with the sensor. Successful pairing will be
indicated by a blue LED triple blink on the Gateway.
d) Once paired, the Gateway will then finalize the connection with the sensor. This will
take approximately 10 seconds and will be indicated by a solid blue LED on the
Gateway. Pairing is complete when the Blue LED starts to blink at 1 second intervals.
e) After the MG100 leaves pairing mode, to connect another sensor, repeat steps (a)
through (d).
f) Once paired, the Gateway connects to the optimyze sensors every 24 hours.
6.3 Unpairing
If the button is pressed and held for 30 or more seconds, upon release the Gateway will
delete all BLE pairing information. A successful unpairing will be indicated with a double-
blink of the blue LED.
6 Operation
optimyze
™
Gateway Instruction, Operation, and Maintenance Manual
9
