6 / 25
If it has to be assumed that safe operation is impossible, the meter has to be put out of operation
and secured against inadvertent putting to operation!
Switch the meter off, pull plug of the mains cable out
of the power supply, and remove the meter from the place of work.
Examples for the assumption that a safe operation is no longer possible,
•
if the package is damaged,
•
if the meter shows visible damages,
•
if the power supply (VER05US050-JA) shows visible damages,
•
if the meter does not function properly,
•
if liquid has penetrated into the casing.
•
if the meter has been altered technologically or if unauthorized personnel tried or succeeded
to open the instrument as attempt to repair it.
In case that the user operates such a device, all thereof resulting risks are on the user.
The meter must not be stored or operated in humid rooms.
The relevant regulations regarding the handling of the substances used have to be observed:
The Decree on Hazardous Matters, the Chemicals Act, and the rules and information of the chemicals trade. It
has to be ensured on the side of the user that the persons entrusted with the use of the meter are experts in the
handling of substances used in the environment and in titrator or that they are supervised by specialised
persons, respectively.
Use only the sensors, sensor cables and interface cables recommended by the manufacturer. The notes
and statements in the respective user manuals and data sheets apply to the use of the sensors and fittings.
The device does not contain any components that need to be replaced and must only be opened for repair
by the manufacturer's technicians.
If in doubt, please contact the supplier.
2
Set up and Commissioning
Scope of delivery
2.1
The scope of delivery is shown on the included packing list.
There is a detailed list of the individual sets in
chapter „Scope of delivery”
Accessories can be found in
chapter „Accessories”
Unpacking and Setup
2.2
The meter and all accessories were carefully inspected for function and size accuracy at the factory.
Please make sure that you also remove all of the small additional parts from the packaging.
The meter can be set up on any even surface.
The safety of the system, in which the device will be integrated, is the responsibility of the installer.
If the meter is transported from a cold into a warm environment, there can be malfunctions in the device
caused by condensate. In this case, you have to wait until the device temperature and the room temperature
have reached a balance before you start the meter.
The flawless function and operational safety of the meter can only be warranted under those climate
conditions specified in
chapter „Specifications”.
Power supply
2.3
The meter is delivered ready to operate with a 5 V DC power supply.
