The work area
Always keep the station clean
Waste and emissions regulations
Observe these safety regulations regarding waste and emissions:
Wash the skin and eyes
Follow these procedures for chemicals or hazardous fluids that have come into contact with your eyes or skin:
•
Make sure that the lifting equipment is in good condition
•
Use a lifting harness, a safety line and a breathing device as required
•
Allow all system and pump components to cool before you handle them
•
Make sure that the product has been thoroughly cleaned
•
Disconnect and lock out power before you service the pump
•
Check the explosion risk before you weld or use electric hand tools
•
Appropriately dispose of all waste
•
Handle and dispose of the processed liquid in compliance with applicable
environmental regulations
•
Clean up all spills in accordance with safety and environmental procedures
•
Report all environmental emissions to the appropriate authorities
Environmental safety
Electrical installation
For electrical installation recycling requirements, consult your local electric utility
Recycling guidelines
Always follow local laws and regulations regarding recycling
WARNING:
Radiation Hazard. Do NOT send the product to Xylem if it has been
exposed to any nuclear radiation
Condition
Chemicals or
hazardous fluids
in eyes
Chemicals or
hazardous fluids
on skin
Action
1. Hold your eyelids apart forcibly with your fingers
2. Rinse the eyes with eyewash or running water for al least 15 minutes
3. Seek medical attention
1. Remove contaminated clothing
2. Wash the skin with soap and water for a least 1 minute
3. Seek medical attention, if necessary
4
