options for identifying the personnel who complete the Work Order. Any workers added
here will then be available for selection in the
Work Performed By
prompt on the HHD
work order screen. Unlike the
Parts
field, this field does not allow user input on the HHD.
The HHD Tab
Individual device parameters can be set or changed on the
Device Control
screen. This
screen can be accessed by clicking the specific device number in the
Tree View
on the
left side of the screen, or by double clicking the desired device in the list of devices on the
Polling Devices
screen.
Note
:
Device parameters may only be changed when there are no routes at a status of Device
Loaded (Data: Loaded) for that particular device; otherwise these options are grayed out.
•
HHD
Tab: This tab denotes that the user is viewing the Device Control for a HHD.
•
AR400X
Tab: This tab allows the user to configure properties found only on the AR4000
model HHDs. If the specific device is not an AR4001 or AR4002 model HHD, the device
will ignore the settings on this tab.
•
AR500X
Tab: This tab allows the user to configure properties found only on the AR5000
model HHDs. If the specific device is not an AR5001 or AR5002 model HHD, the device
will ignore the settings on this tab.
3 Polling Devices | 25
