Installation
DW/P
22
ba77278e01
01/2024
3.2.9 Installing the sensor in the D 17 flow through armature
Before installing a sensor in a flow through armature:
Connect sensors with plug-in head with the AS/IDS-x cable (see operating
manual of the sensor).
Recommendation on the order of the sensors:
To avoid bending sensor cables too much:
Install the sensor with the longest shaft in the flow through arma
-
ture farthest from the cable opening.
figure 3-4 flow through armature for sensors with 17 mm diameter (IDS sensors)
1 Flow through armature
2 Screw gland for fixing the sensor in the flow through armature
3 Sample feed tube
4 Sample outlet tube
5 Screw, for draining the flow through armature
1.
If the drinking water panel was in operation:
Stop the sample feed.
2.
Drain all flow through armatures.
The drinking water panel contains the installation wrench for
the screw glands of the flow through armatures.
3.
Screw on the screw gland with the installation wrench.
3
5
2
1
4
