Multi 3320
Settings
ba77053e04
07/2018
71
10.2.2
Data storage
This menu contains all functions to display, edit and erase stored measured
values and calibration records (see section 11 D
10.2.3 Automatic
Stability control
The automatic
Stability control
(AutoRead) function continuously checks the
stability of the measurement signal. The stability has a considerable impact on
the reproducibility of measured values.
You can activate or switch off the automatic
Stability control
function (see sec-
The measured parameter flashes on the display
as soon as the measured value is outside the stability range
when you switch over between the measured parameters with
<M>
.
when the automatic
Stability control
is switched off.
Manually starting
the
stability control
Irrespective of the setting for automatic
Stability control
(see section 10.2.1
, page 70) in the
System
menu, you can start the
Stability control
func-
tion manually at any time.
System
/
Clock
Date format
Datum
Time
Time and date settings (see
section 4.4.6 E
System
/
Service infor-
mation
Hardware version and software
version of the meter are dis-
played.
System
/
Reset
-
Resets the system settings to
the delivery condition (see sec-
tion 10.3.2 R
Menu item
Possible
setting
Explanation
1.
Freeze the measured value with
<AR>
.
The [HOLD] status indicator is displayed.
If the HOLD function is active, you can, e.g. start a manual mea-
surement with stability control.
