Data storage
Multi 9430
104
ba75966e04
04/2015
10.3 Measurement data storage
10.3.1 Editing the measurement data storage
The contents of the manual or automatic measurement data storage can be
shown on the display.
Each of the measurement data storages has a function to erase the entire
contents.
Editing the
data storage
The storage is edited in the menu,
Storage & config
/
Data storage
. To open
the
Storage & config
menu, press the
<ENTER_>
key in the measured value
display.
Open the manual or automatic storage directly with the
<RCL>
or
<RCL_>
key.
Settings
The settings are explained here using the manual data storage as
an example. The same settings and functions are available for the
automatic data storage.
Menu item
Setting/
function
Explanation
Data storage
/
Manual data storage
/
Display
-
Displays all measurement datas-
ets page by page.
Further options:
Scroll through the datasets
with
<
><
>
.
Output the displayed dataset
to the interface with
<PRT>
.
Quit the display with
<ESC>
.
Data storage
/
Manual data storage
/
Output to USB flash
drive or printer
-
Outputs all stored measured val-
ues to the USB-A interface (USB
memory device/USB printer)
Data storage
/
Manual data storage
/
Output to RS232/USB
-
Outputs all stored measurement
data to the USB-B interface (PC)
Data storage
/
Manual data storage
/
Erase
-
Erases the entire manual mea-
surement data storage.
Note:
All calibration data remain stored
when this action is performed.
