Operation
Multi 3630 IDS
24
ba77170e03
10/2017
4.5.2 Measured value display
In the measured value display, you can
use
<
><
>
to select one of several connected sensors. The selected
sensor is displayed with a colored background.
The following actions / menus refer to the selected sensor
open the menu for calibration and measurement settings with
<ENTER>
(short keystroke)
open the
Storage & config
menu with the sensor-independent settings with
<ENTER_>
(long pressure (approx. 2 s) on
<ENTER>
).
change the display in the selected measuring screen (e. g. pH <-> mV) by
pressing
<M>
.
4.5.3 Menus and dialogs
The menus for settings and dialogs in procedures contain further subelements.
The selection is done with the
<
><
>
keys. The current selection is dis-
played with a frame.
Submenus
The name of the submenu is displayed at the upper edge of the frame. Sub-
menus are opened by confirming with
<ENTER>
. Example:
Settings
Settings are indicated by a colon. The current setting is displayed on the
right-hand side. The setting mode is opened with
<ENTER>
. Subsequently,
Storing in
memory
The meter stores measuring data automatically or manually
Transmit-
ting data
The meter transmits measuring data and calibration records
to a USB-B interface automatically or manually.
Setting
The system menu or a sensor menu with submenus, set-
tings and functions is displayed
Operating
mode
Explanation
General
Interface
Clock function
Service information
Reset
System
30.09.2015 08:00
