pHotoFlex
®
Turb
Operation
33
ba75976e07
09/2021
4.5.2 Settings for photometric measurements
For photometric measurements, the following settings are available in the
Configuration
/
Photometry
menu:
Setting the measured parameter
Displaying a list of all programs
Setting the dilution factor
Switching on or off the analysis timer
Resetting the settings for photometric measurements
The settings are in the menu,
Configuration
/
Photometry
.
Move to the
Configuration
menu with the
<MENU>
key.
Settings
4.5.3 Measuring the concentration
Menu item
Setting
Explanation
Meas. param.
Concentration
% Transmission
Absorbance
Measured parameters in mea-
suring mode
Photometry
Programs
Display all programs with the
corresponding program data
(see section 4.5.8).
Dilution
Set the dilution factor (see
section 4.5.11)
Analysis timer
On
Off
Switch on/off the analysis timer
(see section 4.5.9)
Reset
Reset all settings for the
Pho-
tometry
measuring mode (see
1 Press the
<M>
key (long pressure) repeatedly until the
Photometry
measuring mode is selected.
2 Press the
<M>
key (short pressure) repeatedly until the measured
parameter,
Concentration
is selected.
