pHotoFlex
®
Turb
Operation
75
ba75976e07
09/2021
4.13.1 Administrating user-defined programs with a terminal program
Generally, a terminal program serves to establish a connection to a device on
a data interface and to communicate with the device via a console on the dis-
play.
Thus, it is also possible to send command lines.
Terminal programs are available for different operating systems by different
manufacturers. Windows (version 95 to XP) contains the "HyperTerminal"
terminal program. It is in the program menu under
Accessories
.
For more detailed information please refer to the user information of the ter-
minal program.
The pHotoFlex
®
Turb can administrate the database of user-defined pro-
grams via command lines.
Storing user-
defined programs
Enter a command line according to the following scheme in the terminal pro-
gram:
U.500#14,
Program No
,
Model
,
Cell [mm]
,
Wave length [nm]
,
MRB
,
MRE
,
E0
,
Slope
,
Resolution
,
Citation form
,
Unit
,
Blank required
,0,0
Example:
U.500#14,900,Test,16,436,0.0,2.0,0.0,1.0,0.01,test,mg/
l,0,0,0
Unit
(unit)
e.g. mg/l (max. 7 characters)
Blank required
:
(No/Yes)
0 or 1
On the CD-ROM there is a configuration file for the HyperTermi-
nal program. By double clicking the configuration file (*.ht) you
open the HyperTerminal program with the presettings required
for data exchange with the meter.
1 With the aid of the AK 540/B interface cable, connect the
pHotoFlex
®
Turb to the serial interface (COM port) of the PC (see
2 Make sure the pHotoFlex
®
Turb is switched on.
3 Start the terminal program on the PC.
4 Configure the connection settings for the COM interface as neces-
sary.
Data
Possible entries/examples
