MultiLab 4010-1
Data storage
ba76141e03
03/2014
73
10 Data storage
You can save measured values (datasets) to the data storage:
Manual data storage (see section 10.1 M
Automatic data storage at intervals (see section 10.2 A
Each data storage process transmits the current dataset to the USB interface.
10.1 Manual data storage
You can save a measurement dataset to the data storage as follows. The data-
set is at the same time output to the USB interface:
If the data storage is
full
When all data storage locations are occupied, it is not possible to continue stor-
ing. Then you can e.g. transmit the stored data to a PC (see section 10.3.1
E
, page 76) and subsequently erase
the data storage (see section 10.3.2 E
1.
Press the
<STO>
key shortly.
The menu for manual data storage appears.
2.
If necessary, change and confirm the ID number (1 ... 10000) with
<
><
>
and
<MENU/ENTER>
.
The dataset is stored. The meter switches to the measured value dis-
play.
03.04.2013 07:43:33
pH 7.000 24.8 °C AR +++
ID number:
1
continue
Manual data storage 4 von 500
03.04.2013
08:00
Back
Summary of Contents for YSI MultiLab 4010P-1
