Printer (only MultiLab 4010P-1)
MultiLab 4010-1
84
ba76141e03
03/2014
12.2 Operation / printing
Data are only output to the printer if the following conditions are met
Data are transmitted manually or automatically (see section 11.4 O
the printer is switched on (LED illuminated)
there is no USB connection.
12.3 Printer settings
To open the
Storage & config
menu, press the
<F1__>
/[Menü] key in the mea-
sured value display. After completing the settings, switch to the measured
value display with
<M>
.
Default settings are printed in
bold
.
12.4 Maintenance
12.4.1 Changing the roll of paper (thermal paper)
Menu item
Possible set-
ting
Description
System
/
Printer
/
Font size
12x20
8x16
7x16
Select the font size for the printer
A print sample (character set of the
printer) to view the available font
sizes can be printed with
<OFF_
>.
System
/
Printer
/
Print test page
-
The printer prints the meter informa-
tion from the
System
/
Service infor-
mation
menu.
The current printer settings are
used for the printout
.
1.
Pull the lever (3) until the lid (4) of the paper compartment opens.
2.
If necessary, remove any remains of the old roll of paper.
3.
Insert the new roll of paper. The start of the paper should poke out of
the paper compartment.
4.
Close the lid (4) of the paper compartment so that it clicks into place.
5.
If necessary, move the printer paper forward with
<ON/FEED>
.
Summary of Contents for YSI MultiLab 4010P-1
