Data storage
TruLab pH 1310
50
ba76156e01
03/2014
saving mode switches off functions of the meter that are not required for the
automatic storage of measurement data (such as the display). By pressing any
key the energy saving mode is switched off again.
Terminating the
automatic storage
function prema-
turely
Proceed as follows to switch off the automatic storage function before the
adjusted storage duration has expired:
8.3
Measurement data storage
8.3.1 Editing the measured value storage
The contents of the manual or automatic measurement data storage can be
shown on the display and output to the interface.
Each of the measurement data storages has a function to erase the entire
contents.
Editing the data stor-
age
The storage is edited in the menu,
Storage & config
/
Data storage
. To open
the
Storage & config
menu, press the
<F1__>
[Menu] key in the measured
value display.
Open the manual or automatic storage directly with the
<RCL>
or
<RCL__>
key.
1.
Press the
<STO__>
key.
The following window appears.
2.
Using
<
><
>
, select
Yes
and confirm with
<MENU/ENTER>
.
The meter switches to the measured value display.
The automatic storage function is terminated.
Stop automatic storage?
Yes
No
Warning
01.02.2014
08:00
Back
The settings are explained here using the manual storage as an
example. The same settings and functions are available for the
automatic storage.
Summary of Contents for YSI pH 1310P
Page 70: ...Index TruLab pH 1310 70 ba76156e01 03 2014...
Page 72: ...Contact Information TruLab pH 1310 72 ba76156e01 03 2014...
Page 73: ......
