3
Normal operation 300-360
℃
(572-680
℉
)
Production line operation 360-410
℃
(680-770
℉
)
When the soldering iron’s working temperature is set within the parameters suitable
for the type of soldering being used, a good joint assured. Too low of a temperature
will slow the rate of solder flow while a high temperature setting might burn the flux
in the solder and emit a heavy, white smoke resulting in a dry joint or permanent
damage to the printed circuit board (P.C.B) and may also shorten tip life.
IMPORTANT
: The temperature above 410
℃
(770
℉
) is not recommended for
normal soldering functions, but can be used for short periods of time when high
temperatures are required.
OPERATING INSTURCTIONS
OPERATING PROCEDUCRES FOR LF-8000:
1.
Ensure that the working voltage matches your power supply before beginning use.
2.
Check carefully for any damage during transportation.
3.
This unit contains:
A: DIA80: Desoldering iron assembly with tip.
B: 210ESD: Soldering iron assembly with tip.
C: Two iron holders with tip cleaners for both soldering and desoldering.
D: AC Power cord with plug.
Accessories included:
a.
One cleaning brush
b.
One cooling strip
c.
One 0.
7∮ probe
d.
4pcs of filters
4. Optional parts:
A) TWZ100: 32V/100W Tweezers can be interchangeable with 210ESD soldering
iron.
B) Fume extraction kit: For soldering iron only
C) HAP80: 32V/80W Hot air blow pencil can be interchangeable with DIA80.
OPERATING PROCEDUCRES
1.
Ensure that the base unit’s power switch is in the ‘OFF” position.
2.
Plug in “Solder and Desolder” wands, connect “Vacuum tube” to “VAC”.
3.
Connect AC power cord to mains “In-Let”.
Summary of Contents for LF-8000
Page 14: ...13...
