10
2. After the unit enters the Modes selection, the LED will display “F-0”and flash.
Press “▲”or “▼” key to select modes. If the user doesn’t press “▲” or “▼” key within 15
seconds or press “SET” key one time, then the unit will be immediately back from the Parameter
Set status.
For example: F-0 → F-1 → F-2
↑ ↓
← ← ←
3. Password Setting:
When the LED displays “F-1” and flashes, press “SET” key one time and the unit enters the
Password Set status. At this moment, the LED displays the pre-set value. Press “▲” or “▼” key to
change password set value. If the user sets “000” that means the unit will be under the status of no
password. If the user sets “100” then means the unit will be under the password status. Press
“SET” key once to finish password setting and the unit will backup mode, the user can continue
set other modes or back from the setting mode.
4. Fahrenheit and Centigrade (Celsius) temperature selection
When temperature display window shows "F-4" and blinking, press the "SET" button, at this time,
the system enters the degrees Fahrenheit and Centigrade temperature selection function, indicating
the temperature of the window shows the current status. Press "▲" or "▼" key to change the
temperature selection status. It expressed as degrees Celsius temperature value if set to
℃
; it
shows as degrees Fahrenheit temperature if set to
℉.
OPERATING INSTRUCTIONS
NOTE: In order to protect the pump during transportation,
the pump in the machine is tightened
by the 4 screws under the bottom enclosure. Please unscrew the 4 screws when the machine is used
at the first time
. (See Fig. A).
Fig. A
