4
◆
DELAYED SUCTION: To eliminate the problem of solder clogging up the tip, a delayed switch
feature has been incorporated for the unit that allows the pump to continue sucking for 1.5
seconds after the actuator switch is released.
◆
LIGHTWEIGHT SOLDERING IRON: Ergonomic mini handle that stays cool and prevents
operator fatigue.
◆
ENERGY SAVER MODE: If the station has been idle for 20 minutes, the energy
saver feature will automatically engage, the temperature goes down to 150
℃
from the set
temperature for Soldering and 200
℃
from the set temperature for de-soldering Activating the
solder/desolder wands will disengage the power saving feature and the unit will immediately
ramp up to the preset temperature. When over 40 minutes without operation the main power will
be switched off to “sleep mode” which cuts power consumption and extends tip life.
Please note:
You have to turn off the power switch first and then switch “ON” again to
commence work when the unit goes to “Sleep” mode.
◆
IRON WORKING OPTION: When the users don’t use the soldering or desoldering function ,or
they also set by pressing keys “ SET
+ ▲”,
at this time, the iron which you set will enter the
power off suspend status. It means that the heater power is cut off. If press “
▼”then
the heater
power will be on.
◆
OPTIONAL SMD TWEEZERS : The additional feature is specially designed for SMD chips,
SOT, Flat pack ICs’ etc. reworking. TWZ90 Tweezers can be interchangeable with soldering iron as
an option. Be sure before proceeding this operation, the main switch must be “OFF” to avoid any
damage to the unit.
Hot Air Funciton
◆
With the high power heating element, heat up quickly, the momentary power can reach 600W.
◆
Temperature adjustable, suits for removing QFP, SOP, PLCC or SOJ chips etc.,
especially the built in static free circuit design is safety for the sensitive elements like CMOS ICs.
◆
SENSOR /PUMP FAILED DETECTION: If sensor circuit failed that the display read “S--E” and
cut off the heater power. If the pump circuit failed that the display read ”P-E” and cut off the
heater power.
◆
Auto-cooling design: When the power switch off, the cooling system will begin to work
automatically, the temperature falls down to 100
℃(212℉)
to protect the heating element from
burning ..
◆
Heating element auto-protecting function: When heating element reaching a high
temperature which can be protected automatically, to lasting the life of heating element.
