12
2.
Slide out the solder collector as in Figure 11. (CAUTION: The solder collector is
glass and thus retains heat, handle with care!)
FIG-11
3.
Point the collector down while shaking slightly (see Figure 12.) and the waste solder
will fall out. This task must be carried out periodically for proper operation of the
station.
FIG-12
4.
Remove cooling strip with a pair of long nose pliers or tweezers.
(see Figures 13 & 14)
FIG-13 FIG-14
5.
Clean the cooling strip and glass collector with wire brush (included).
PROCEDURE FOR REPLACING FILTERS
SOLDER COLLECTOR FILTERS
1.
Be sure the iron/filter assembly have cooled.
2.
Hold iron as in Figure 10, press/turn red knob on the butt of iron.
3.
Remove solder collector (see Figure 11).
4.
Disassemble the solder collector into 2 pars (see Figures 15 & 16).
Dystrybucja i serwis
Dane kontaktowe:
NDN - Zbigniew Daniluk
ul. Janowskiego 15
02-784 Warszawa
tel.: (22) 641-15-47
e-mail: ndn@ndn.com.pl
NIP: 521-044-00-73
